How to use the keyboard tester
Press Start test or click the drawing, then press every key once. Each key flashes while it is held and stays shaded once it has been pressed. The counter and the Not tested yet list show what is left. Pick ANSI if your Enter key is wide and flat, or ISO if it is tall and there is an extra key next to Left Shift. Choose No numpad for laptops and tenkeyless boards.
While the test runs, the page blocks the normal effect of keys such as Tab, Space, the F-keys, arrows, Backspace and /, so you can press them without scrolling or opening a search bar. Press Esc twice, or click anywhere outside the tester, to give the keys back to the browser. If you switch windows, the test pauses until you click it again.
Reading the results
Max rollover is the largest number of keys the browser saw held down at the same moment. Hold keys one by one without releasing and watch the number. When it stops going up, or a key you press does not light, you have hit the keyboard's limit for that group of keys.
This is where ghosting and NKRO come in. Most cheap keyboards wire keys in a grid. Hold certain three-key combinations and the controller cannot tell which keys are really down, so it either drops the next key (often called blocking or ghosting) or reports a key you never pressed. Keyboards with a diode per switch avoid this and are sold as anti-ghosting or n-key rollover (NKRO). A USB keyboard in basic "boot" mode reports at most six normal keys plus modifiers, so an NKRO board may show 6 in some modes. Try combinations you use in games, such as W+A+Shift+Space.
Fixing key chatter
Chatter is one press that the keyboard reports as two or more. The tester flags a key that goes down again within the set time after it was released, or that goes down twice with no release in between. Real fingers rarely re-press a key that fast.
- Clean it. Dust and crumbs under a switch cause erratic contact. Blow compressed air around the keycap, or pull the keycap and clean beneath it.
- Raise the debounce time. Many gaming keyboards and boards running QMK or VIA firmware let you set debounce in their software. A few milliseconds more often hides a worn switch.
- Replace the switch. On hot-swap boards, pull the switch and fit a new one. On soldered boards it needs desoldering, or a warranty claim.
Laptop keyboards and layouts
Laptop keyboards usually have lower rollover than desktop boards, and the Fn layer is handled inside the laptop, so Fn+F5 may show up as a brightness change, not a key. The browser names keys by their US position, so on a French AZERTY board pressing A lights the key in the Q position; Chrome and Edge relabel the drawing to match your layout.
Checking a full setup? The mic test and webcam test cover calls, the gamepad tester checks controllers, and the dead pixel test checks your screen.